Plastic mold manufacturer ： Plastic mold Meet the technical requirements of mold development

The plastic mold meets the mold development technical requirements

1. The parting surface of the plastic mold should be smooth, free of pits, rust spots, handwheels, air circulation, and the sealing part should be free of dents or cracks.

2. The plastic mold sets the mold, moves the mold muscle position, cylinder surface, no fire marks, knife marks, and completes in place.

3. When inserting the plastic mold, there is no thin blade structure, the angle is greater than 2 degrees, and there is no black mark, puncture and other defects.

4. Module products in Injection mould The left and right sides of the cavity are symmetrical, so it is necessary to display the left or right side. If the position and size required by the customer are based on the customer's requirements, if the customer has no requirements, they should be at the place that does not affect the appearance and assembly (for example, the font size is "1/8").

5. The plastic mould has the same mark and is similar, so it is easy to mix during installation.

6. The design of large and medium-sized molds is to add pressure balance blocks and nitrogen treatment on the mold surface.

7. Insert the non integrating surface dynamic mode into the fixed mode, or insert the fixed mode into the dynamic mode to lock the slope or avoid the air.

8. The plastic mold, mold frame and injection parts meet the technical requirements of mold development.

9. Customers' requirements for engraving characters on the surface of plastic mold products.