For example, a customer asked that the product be installed on the surface for aesthetic purposes. When designing plastic molds, our designers should try to ensure that the appearance of plastic parts is smooth

, beautiful and generous. Try to make sure that the customer sees no defects at a glance. Therefore, during the design, the surface of plastic parts should try not to use various kinds of sliders, slider traces,

Parting line and so on. If the mold is designed like this, the structure will become complex. Some molds even need to make internal slide blocks, internal top blocks and so on. The mold feed port should also select the potential

Volt type, side feeding or point feeding. Prevent damage to the appearance of products.

If the plastic injection molding parts of the product are used inside, we usually refer to those invisible on the outer surface, which are completely placed inside. Then we don't consider the product in design

beautiful. Reduce the complex structure of the mold, and ensure the strength of plastic injection molded parts while ensuring that the plastic parts can be smoothly detached from the mold. Reduce deformation of plastic parts.

In this way, in terms of materials used for products, we will basically choose some reinforced plastics, such as reinforced nylon, tempered plastics, etc. Hardness and plastic deformation index of this material

There are relatively few. High hardness, not easy to deform. But the appearance of the injection molded products is not good. Therefore, this product is usually only used inside various products. But for products and products

If the assembly requirements are relatively high, the use of this plastic injection raw material can meet some high requirements.